Date: Mon, 2 Jul 2001 09:12:18 +0200 (CEST) From: Stefan Fent <sf@suse.de> Message-ID: <Pine.LNX.4.33.0107020903360.7158-100000@d71.suse.de> Subject: Re: [suse-axp] SuSE 7.1 install problems on DS20
Hi,
On Fri, 29 Jun 2001, Markus Lischka wrote:
> Date: Fri, 29 Jun 2001 17:54:35 +0200 (CEST)
> From: Markus Lischka <Markus_Lischka@Physik.TU-Muenchen.DE>
> To: suse-axp@suse.com
> Subject: [suse-axp] SuSE 7.1 install problems on DS20
>
> We have trouble getting SuSE 7.1 installed on a DS20E: After booting from
> CD using the standard aboot configuration (/etc/vm_full.gz), the kernel is
> loaded but then stops with the message "please insert root floppy disk and
> press enter" (although the ramdisk had already been loaded by aboot and
> the cd-rom is properly detected). On our XP1000, the installation
> procedure just continues with the message "RAMDISK: ..." loads linuxrc.
> Using the 2.4 kernel (CD1:/etc/vm_24.gz kernels) results in a kernel panic
> before linuxrc is started :(
>
> Booting from floppy disks (aboot_xx, install_xx) does not work either but
> stops when reading the root disk (ext2 read error). The same disks work on
> two different XP1000s though.
>
> Our configuration: DS20E, 2x 21264 CPUs, 256MB + 2GB RAM, 18GB HD,
> Firmware SRM-6.0 (standard Compaq configuration).
>
> What's going wrong here?
Aboot loads the initrd at the very end of phys. RAM, but the kernel only
sees 2GB, so it can't read the initrd anymore (on machines >2GB).
The solution is to use the image 'install' (not install_xx) and boot:
>>>b <boot-device> -fi /etc/vm_full.gz -fl "root=/dev/fd0 fake_initrd"
>
> Any hints are greatly appreciated,
> Markus Lischka
With kind regards,
Stefan Fent
-- SuSE GmbH, Tel: +49-911-7405331 Schanzaeckerstr. 10, Fax: +49-911-3206727 90443 Nuernberg, Email: sf@suse.de Germany WWW: http://www.suse.dewarning: declaration does not declare anything
This archive was generated by hypermail 2.1.0 : Mon Jul 02 2001 - 00:11:23 PDT