From: Rafa Grimán (rgriman_at_sgi.com)
Date: Mon Jun 19 2006 - 13:55:30 CEST
From: Rafa Grimán <rgriman@sgi.com> Date: Mon, 19 Jun 2006 13:55:30 +0200 Message-Id: <200606191355.31073.rgriman@sgi.com> Subject: Re: [suse-sles-e] Problem with network and FW
Hi :)
Sorry for the late reply but was out of the office and had no Inet acces :( I
don't know if you got it to work. In any case ...
El Viernes, 9 de Junio de 2006 16:05, Stefan Jakobs escribió:
> Am Freitag, 9. Juni 2006 13:37 schrieb Rafa Grimán:
> > Hi :)
> >
> > > - Adding a rcScript, that runs "ifconfig bond0 add 192.168.11.23" at
> > > startup
> >
> > Why do you run this script, it's not needed for channel bonding?
>
> I need a virtual interface (bond0:0) and I couldn't figure out how to do
> this with the ifcfg files. But that's an other story.
You have to add a couple of lines to the ifcfg-bond0 file ... but that's
another story ;)
> > There's a very simple way to setup channel bonding:
[...]
> OK. I changed my settings, but I get the same failure after reboot. With
> plugged in network cable the server hangs after starting the network. And
> with plugged out network cable the server starts without any problem.
>
> > That should get you going :)
>
> Unfortunately not. :(
OK :) Can you send us the following files:
ifcfg-eth*
ifcfg-bond0
/etc/modprobe.conf.local
Just copy'n'past them here.
Rafa
-- "Even paranoids have enemies." Rafa Grimán Systems Engineer Silicon Graphics Spain Santa Engracia, 120 - Planta Baja 28003 Madrid Spain Tel: +34 91 3984200 Tel: +34 91 3984201 Móvil: +34 628 117 940 http://www.sgi.com OpenWengo: rgriman Skype: rgriman --------------------------------------------------------------------- To unsubscribe, e-mail: suse-sles-e-unsubscribe@suse.com For additional commands, e-mail: suse-sles-e-help@suse.com
This archive was generated by hypermail 2.1.7 : Mon Jun 19 2006 - 13:55:47 CEST