From: Ian Donaldson <ian@dsd-tech.co.uk> Date: Mon, 04 Dec 2000 15:24:26 GMT Message-ID: <20001204.15242600@donaldson.home> Subject: Re: [suse-sparc] /floppy
>>>>>>>>>>>>>>>>>> Original Message <<<<<<<<<<<<<<<<<<
On 12/3/00, 10:49:14 PM, Joshua Uziel <uzi@suse.com> wrote regarding Re:
[suse-sparc] /floppy:
> Ok, two things to do... first off, mofidy the drivers/block/Makefile
> file at line 23... change:
> L_OBJS := genhd.o ide-geometry.o
> to
> L_OBJS :=
> Then... in your make menuconfig, under "General setup", make sure that
> you have "PCI support" (CONFIG_PCI) off.
> Let me know if this works for you. :)
Still no luck, I still get the same errors about sparc not supporting
ide, but thanks any way. I can get around the problem by exporting my
PC's floppy a bit long winded but there you are.
Regards Ian Donaldson
Newtownards
Northern Ireland
ian@dsd-tech.co.uk
ian@ards.freeserve.co.uk
This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:08:26 PDT