RE: [suse-sparc] /floppy

From: Witvliet, Hans (Hans.Witvliet@Alcatel.nl)
Date: Mon Dec 04 2000 - 07:43:03 PST

  • Next message: Thorsten Kukuk: "Re: [suse-sparc] /floppy"

    Message-ID: <1A8904C3797ED411AC2E0008C7E6F88117C684@nlntmail2b.ats.nld.alcatel.nl>
    From: "Witvliet, Hans" <Hans.Witvliet@Alcatel.nl>
    Date: Mon, 4 Dec 2000 16:43:03 +0100 
    Subject: RE: [suse-sparc] /floppy
    

    Hi Ian,

    As you asked for any comment.....
    You're working on a SS5, which has only scsi and no IDE interface
    So I assume it is quite logical that there is no IDE-support for sun-4m
    machines.....

    Hans
    > -----Original Message-----
    > From: Ian Donaldson [SMTP:ian@dsd-tech.co.uk]
    > Sent: Sunday, December 03, 2000 7:37 PM
    > To: Joshua Uziel
    > Cc: suse-sparc@suse.com
    > Subject: Re: [suse-sparc] /floppy
    >
    > >>>>>>>>>>>>>>>>>> Original Message <<<<<<<<<<<<<<<<<<
    >
    > On 12/3/00, 12:03:59 AM, Joshua Uziel <uzi@suse.com> wrote regarding Re:
    > [suse-sparc] /floppy:
    >
    >
    > > * Ian Donaldson <ian@dsd-tech.co.uk> [001202 16:00]:
    > > > Sparc5 (running a freshly installed copy of SuSE 7 of course) cannot
    > > > mount the floppy. I keep getting the following error messages :-
    > > >
    > > > "/dev/fd0 has wrong major or minor number" with command "mount
    > /floppy"
    > > > I also get the above error when I try to mount it using vfat
    > > >
    > > > "fs type dos not supported by kernel" with command "mount -t dos
    > /dev/fd0
    > > > /floppy" I also get the above error when I try to mount it using fat
    > > >
    > > > Does the default kernel not support windows formated floppy's at all.
    >
    > > Nope... this is a known problem... just rebuild a kernel with it
    > > enabled and it'll work...
    >
    > I installed the kernel sources and did a "make menuconfig" I set the file
    > types fat, VFAT and DOS as built in rather than loadable modules and left
    > everything as default. I then did "make dep" everything fine, I then did
    > "make vmlinux" which after a few minutes stopped with error messages
    > something about IDE not supported under Sparc. I went back into
    > menuconfig but
    > I couldn't find anything about IDE support. Any ideas as I am completely
    > lost.
    >
    >
    > Regards Ian Donaldson
    >
    > Newtownards
    > Northern Ireland
    > ian@dsd-tech.co.uk
    > ian@ards.freeserve.co.uk



    This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:08:26 PDT