Re: [suse-sparc] ATTO SCSI

From: Mike Renner (mr@memphis-computer.com)
Date: Wed Dec 20 2000 - 01:51:11 PST

  • Next message: Thomas van Brackel: "Linux on Sparc 2" 

    Message-ID: <3A40810F.9E9FBB8B@memphis-computer.com>
Date: Wed, 20 Dec 2000 10:51:11 +0100
From: Mike Renner <mr@memphis-computer.com>
Subject: Re: [suse-sparc] ATTO SCSI

    hi

    i use this adapter with suse-linux on a x86-pc with the ncr53c8xx-module
    (the ul2s have an lsi-logic(symbios) 53c895-chipset) and another one on
    a ultra5 (with solaris). with the solaris i have to flash a lsi-bios on
    that card, otherwise it donīt work. probe-scsi showed the correct type,
    but the drives were not recognized. i donīt know, if the change of the
    card-bios is neccessary with linux. but i think you should first try the
    ncr-module...

    mike

    sc843@bard.edu schrieb:
    >
    > Dear mailing list,
    >
    > I have an Ultra 5 running SuSE beautifully. I want to add a SCSI adapter so I
    > installed an ATTO ExpressPCI UL2S.
    >
    > Now, this card is recognized just fine by the BIOS (as shown by probe-scsi-all),
    > has lots of good little lights, but I'm not sure how to configure it in Linux.
    >
    > I get messages like these:
    >
    > scsi: 0 hosts.
    > scsi: detected total.
    >
    > Is this a SuSE/sparc issue or do I need to take it somewhere else?
    >
    > Sincerely,
    >
    > Sean Callanan

    This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:08:30 PDT