Date: Thu, 21 Dec 2000 17:57:40 -0800 From: Joshua Uziel <uzi@suse.com> Message-ID: <20001221175740.D25566@gimp.org> Subject: Re: [suse-sparc] Newbie needs help: configing 2 ethernets with yast2
* Bob Myers <rjmyers1@gte.net> [001221 17:44]:
> > Is it not being seen at boot time? What does a "dmesg | grep eth" show?
>
> dmesg|more shows the following:
>
> ...
> eth0: LANCE 08:00:20:4d:f4:9d
> eth0: using auto-carrier-detection.
> eth1: LANCE 08:00:20:4d:f4:9d
> ...
>
> Both show up during boot. Noticed that a message regarding eth0
> showed up about carrier lost, trying TPE -- no message on eth1 however.
Disregard that message... anyways, looks like things are more or less
"fine" as far as that goes...
> I found this on the first cdrom and did what you suggested. Not sure
> how to proceed until eth1 is picked up by the yast2 lan installation
> program...
Well, you want to remove dhcpcd and install dhclient either way... if
you have problems with yast2, then perhaps try using yast1 for the
network configuration.
This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:08:31 PDT