Message-ID: <3ACE1DDA.8000205@louisw.org> Date: Fri, 06 Apr 2001 12:49:46 -0700 From: Nate Locke <nlocke@louisw.org> Subject: Re: [suse-sparc] Partitioning Hard Drives on Ultra Creator I
the command prompt way to partition in Linux is: fdisk
usually it is followed by the drive info.
so if for example your scsi disk is on ID #3, that would be fdisk /dev/sdd
sda = scsi drive 1, sdb = scsi drive 2, and so on.
Walker, John wrote:
> Where can I find some specific information on partitioning multiple hard
> drives on my Ultra Creator I. Have a 2GB internal SCSI drive and 2 external
> 2GB SCSI drives. The YAST2 installer with Suse-Sparc 7.1 will only allow me
> to select one of the drives for partitioning in the "automatic" install
> mode. Don't know enough about partitioning drives under linux yet to go
> into "expert" install mode. Tried some brief searches for partitioning info
> on a Suse-Sparc setup but only seem to find "How-To's" for Intel based
> machines. Any pointers or leads on where I can get the info would be most
> appreciated.
>
> John Walker
>
>
This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:09:00 PDT