AW: WG: [suse-sparc] boot / installation problem 7.3 SunBlade 100

From: Moeller Daniel (QI/CCE2-SI) * (Daniel.Moeller@de.bosch.com)
Date: Tue Dec 04 2001 - 08:41:11 PST

  • Next message: Thorsten Kukuk: "Re: WG: [suse-sparc] boot / installation problem 7.3 SunBlade 100" 

    Message-ID: <1121C3ABCA53C945B821A821CDD67F62F68544@simail21.desi2.bosch.com>
From: "Moeller Daniel (QI/CCE2-SI) *" <Daniel.Moeller@de.bosch.com>
Date: Tue, 4 Dec 2001 17:41:11 +0100 
Subject: AW: WG: [suse-sparc] boot / installation problem 7.3 SunBlade 100

    Hi Thorsten,

    the graphics card is an Expert 3D. I guess this card is not supported, as
    the "lite" version is not supported too.
    hwinfo --display says:
    Model: "Intergraph VGA compatible controller"
    Vendor: 1091 "Intergraph Corporation"
    Device: 07a0 "?"
    SubVendor: 1091 "Intergraph Corporation"
    SubDevice: 0108 "?"
    Revision: 0x64

    Do you need the other lines, too?

    Kind regards,
    Danny

    -----Ursprüngliche Nachricht-----
    Von: Thorsten Kukuk [mailto:kukuk@suse.de]
    Betreff: Re: WG: [suse-sparc] boot / installation problem 7.3 SunBlade
    100

    On Tue, Dec 04, Moeller Daniel (QI/CCE2-SI) * wrote:

    > Hi list,
    >
    > I'm able to boot a SunBlade 1000 with the same boot CD I tried with the
    > Blade 100. I'm getting through to Yast, but Yast can't recognize the
    > graphics card and therefor is in character mode and the installation can't
    > find the FibreChannel internal disk.

    I never had a FibreChannel disk for testing, so yes, this has to fail.
    My has an extra SCSI card with a SCSI disk on it.
    To the graphics card: Can you switch to tty2 and run "hwinfo --display" ? 

    -- 
To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com
For additional commands, e-mail: suse-sparc-help@suse.com

    This archive was generated by hypermail 2.1.0 : Tue Dec 04 2001 - 09:24:45 PST