OpenBoot and SILO

From: root (mail@tplusplus.de)
Date: Fri Feb 02 2001 - 06:33:23 PST

Next message: Bob Allen: "DHCP setup problems with SuSE 7.0 on Sun Ultra/10"

Previous message: Mike Nicewonger: "Re: [suse-sparc] Frame-Buffer/Video-Card from Parallax"
Next in thread: Joshua Uziel: "Re: [suse-sparc] OpenBoot and SILO"
Reply: Joshua Uziel: "Re: [suse-sparc] OpenBoot and SILO"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Message-ID: <3A7AC533.30EB9468@tplusplus.de>
Date: Fri, 02 Feb 2001 15:33:23 +0100
From: root <mail@tplusplus.de>
Subject: OpenBoot and SILO

Hello!

I got Linux up and running on my Ultra 10. Linux is installed on my
second external SCSI disk (/dev/hdb1). I installed SILO there, too.
So the boot command in OpenBoot should be

boot /pci@1f,0/pci@1/scsi@1/disk@2,0

When I try this, it says something like "The file just loaded does
not seem to be an executable".

I've tried adding :a (for first partition), no change there.

When I boot from the installation CD and then select
boot installed system - /dev/hdb1, it boots just fine.

Toby

Next message: Bob Allen: "DHCP setup problems with SuSE 7.0 on Sun Ultra/10"
Previous message: Mike Nicewonger: "Re: [suse-sparc] Frame-Buffer/Video-Card from Parallax"
Next in thread: Joshua Uziel: "Re: [suse-sparc] OpenBoot and SILO"
Reply: Joshua Uziel: "Re: [suse-sparc] OpenBoot and SILO"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:08:38 PDT