Installing a Sun Ultra 1 with Suse 7.0 Sparc version

• Previous message: Joshua Uziel: "Re: [suse-sparc] Help with Kernel Build"
• Next in thread: Barry Roberts: "Re: [suse-sparc] Installing a Sun Ultra 1 with Suse 7.0 Sparc version"
• Reply: Barry Roberts: "Re: [suse-sparc] Installing a Sun Ultra 1 with Suse 7.0 Sparc version"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

From: "Wayne Ringling" <wayne@digitalwebtech.net>
Date: Fri, 5 Jan 2001 22:38:44 -0500
Message-ID: <ICENJBAIJDEJHAFJKEGBGEILCFAA.wayne@digitalwebtech.net>
Subject: Installing a Sun Ultra 1 with Suse 7.0 Sparc version

 I have read on the archives about a problem with SILO and YAST2. They seem
to recommend using YAST1 to do part of the install then use YAST2 to finish
it. Well I am setting up a new ultra 1 with a pair of new 18gb drives in
it. I presume that I have to make the boot partition less than 2 gb (no
problem there) are there any other limitations I should consider? How do I
go from YAST1 to YAST2? Or is the current version of SuSe 7.0 for sparc
installing properly now?

Wayne

• Next message: Barry Roberts: "Re: [suse-sparc] Installing a Sun Ultra 1 with Suse 7.0 Sparc version"
• Previous message: Joshua Uziel: "Re: [suse-sparc] Help with Kernel Build"
• Next in thread: Barry Roberts: "Re: [suse-sparc] Installing a Sun Ultra 1 with Suse 7.0 Sparc version"
• Reply: Barry Roberts: "Re: [suse-sparc] Installing a Sun Ultra 1 with Suse 7.0 Sparc version"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:08:32 PDT