From: jyoung82@carolina.rr.com Date: Fri, 18 May 2001 05:03:02 -0400 Message-ID: <9on9gt0je94je5h5jhcqg3kicu3160t39m@4ax.com> Subject: Scsi Host not detected with Suse 7.1 on Netra t1 105
Hello,
I have a Netra t1 model 105 which I am attempted to install Suse Linux 7.1
(Sparc). This is a headless box which I am accessing via Serial A. I can
issue a 'boot cdrom' and the system will boot to the SILO prompt. Here I just
press 'enter' and the system boot messages scroll across the terminal window.
After a few seconds I see the message:
No hard disks could be found for installation
Please check your hardware
After this, I press "enter" and the Linuxrc v1.1.18 window appears. I coose
"System information" and then "Kernel messages" and below is what I see. Note
that it reports 0 Scsi hosts found. The system came equipped with Solaris 8
preinstalled and it boots fine so I know the SCSI system works.......Any ideas?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
PROMLIB: Sun IEEE Boot Prom 3.10.25 2000/01/17 21:26
Linux version 2.2.18 (root@UltraSPARC.suse.de) (gcc version egcs-2.92
ARCH: SUN4U
Ethernet address: 08:00:20:f9:bf:dc
Calibrating delay loop... 878.18 BogoMIPS
Memory: 514200k available (1624k kernel code, 6256k data, 128k init)
Dentry hash table entries: 65536 (order 7, 1024k)
Buffer cache hash table entries: 524288 (order 9, 4096k)
Page cache hash table entries: 131072 (order 7, 1024k)
Inode hash table entries: 32768 (512k), inode-max: 32688
VFS: Diskquotas version dquot_6.4.0 initialized
POSIX conformance testing by UNIFIX
PCI: Probing for controllers.
PCI: Found SABRE, main regs at fffff9fe00000000 CTRL[0000000000000000
SABRE: PCI config space at fffff9fe01000000
SABRE: DVMA at c0000000 [20000000]
PCI: Probing PCI hardware
ebus0: fffff9fff0000000[1000000] fffff9fff1000000[800000]
power: Control reg at fffff9fff1724000 ... powerd running.
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 524288 bhash 65536)
Initializing RT netlink socket
Starting kswapd v 1.5
PCIO serial driver version 1.18.2.7
su(serial) at 0xfffff9fff13803f8 (tty 0 irq 6,7dc) is a 16550A
su(serial) at 0xfffff9fff13602f8 (tty 1 irq 6,7d4) is a 16550A
pty: 256 Unix98 ptys configured
RAM disk driver initialized: 16 RAM disks of 64000K size
loop: registered device at major 7
CMD646: IDE controller on PCI bus 03 dev 70
ide0: BM-DMA at 0xfffff9fe02001020-0xfffff9fe02001027, BIOS setti
ide1: BM-DMA at 0xfffff9fe02001028-0xfffff9fe0200102f, BIOS sett
hdc: TOSHIBA CD-ROM XM-7002Bc, ATAPI CDROM drive
ide1 at 0x2001010-0x2001017,0x200101a on irq 4,7c2
hdc: ATAPI 24X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.11
md driver 0.90.0 MAX_MD_DEVS=256, MAX_REAL=12
linear personality registered
raid0 personality registered
raid1 personality registered
raid5 personality registered
raid5: using high-speed VIS checksum routine
scsi : 0 hosts.
scsi : detected total.
^^^^^^^^^^^^^^^^^^^
^^^^^^^^^^^^^^^^^^^
md.c: sizeof(mdp_super_t) = 4104
Partition check:
RAMDISK: Compressed image found at block 0
Uncompressing.......................................................
autodetecting RAID arrays
autorun ...
... autorun DONE.
VFS: Mounted root (ext2 filesystem)
Unimplemented SPARC system call 69
kmod: failed to exec /sbin/modprobe -s -k char-major-4, errno = 2
Unimplemented SPARC system call 69
Unimplemented SPARC system call 69
Unimplemented SPARC system call 69
Unimplemented SPARC system call 69
VFS: Disk change detected on device ide1(22,0)
Unimplemented SPARC system call 69
ISO 9660 Extensions: Microsoft Joliet Level 3
ISO 9660 Extensions: RRIP_1991A
This archive was generated by hypermail 2.1.0 : Wed Jun 06 2001 - 11:09:13 PDT