Re: [suse-sparc] Ctrl-C doesn't work via a minicom session.

From: Joshua Uziel (uzi@uzix.org)
Date: Wed Oct 17 2001 - 11:33:08 PDT

  • Next message: Sepp Käsbauer: "Re: [suse-sparc] Terminal unset during serial install." 

    Date: Wed, 17 Oct 2001 11:33:08 -0700
From: Joshua Uziel <uzi@uzix.org>
Message-ID: <20011017113308.O2932@uzix.org>
Subject: Re: [suse-sparc] Ctrl-C doesn't work via a minicom session.

    * Bill Schoolcraft <bill@wiliweld.com> [011017 09:52]:
    > In running minicom from a (Intel) Linux into the Sparc Linux I was
    > setting up the network and decided to "ping" a target to confirm my
    > connection.
    >
    > After doing so I could not use [Ctrl]+[C] or any other combination
    > to to abort the command.
    >
    > Anyone faced this before ?

    I've seen this before when the console device (on the SPARC) is set to
    use /dev/console. Instead, try switching it in /etc/inittab to use
    ttyS0 like so:

            T0:23:respawn:/sbin/getty -L ttyS0 9600 vt102

    Another thing (if that isn't the case) is to attempt playing with your
    serial settings... flow control, etc.

    Good luck. :) 

    -- 
To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com
For additional commands, e-mail: suse-sparc-help@suse.com

    This archive was generated by hypermail 2.1.0 : Wed Oct 17 2001 - 11:37:53 PDT