Re: [suse-sparc] 100 Full Duplex

From: Kevin Pfeiffer (pfeiffer_at_iu-bremen.de)
Date: Sun Dec 22 2002 - 01:21:28 CET

  • Next message: Sascha Uhl: "[suse-sparc] eth0 down" 
    From: Kevin Pfeiffer <pfeiffer@iu-bremen.de>
Date: Sun, 22 Dec 2002 01:21:28 +0100
Message-Id: <200212220121.28742.pfeiffer@iu-bremen.de>
Subject: Re: [suse-sparc] 100 Full Duplex

    Block, John writes:
    > How do I tweak the network prams to force the interface to go 100 Full
    > Duplex. We have Cisco switches here that the Sun interface doesn't like
    > to auto negotiate to 100 Full with, so we hard code it in the /etc/system
    > file under Solaris, but where do I tweak that in SUSE?

    I think I have the same question, inasmuch as the hub behind timo doesn't
    light up for the 100 setting...

    Otherwise the new Sparc/Linux machine is doing fine. Only hitch so far is
    that I discovered that I don't have the Perl::Magick module installed and
    can't install it until I install a C compiler (for 'make'?). I'll do this
    on Monday when I'm in the same room with machine and CD-ROM drive.

    -K 

    -- 
Kevin Pfeiffer <pfeiffer@iu-bremen.de> - www.iu-bremen.de
Online Editorial Services - International University Bremen
"The rule still applies. However, this rule will not be enforced."

    -- 
To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com
For additional commands, e-mail: suse-sparc-help@suse.com

    This archive was generated by hypermail 2.1.4 : Sun Dec 22 2002 - 01:21:00 CET