Re[2]: [suse-sparc] Elite 3d installation

From: Till Jaeger (till.jaeger@epost.de)
Date: Mon Feb 11 2002 - 11:29:34 PST

Next message: Till Jaeger: "Re: AW: [suse-sparc] Elite 3d installation"

Previous message: Kuhnkey, Mike E (N-Raytheon): "[suse-sparc] Installation: Sax2 and XFree86 for Sun Elite3D/Expert3D"
In reply to: Jerry Acord: "Re: [suse-sparc] Elite 3d installation"
Next in thread: Till Jaeger: "Re[2]: [suse-sparc] Elite 3d installation"
Reply: Kuhnkey, Mike E (N-Raytheon): "RE: Re[2]: [suse-sparc] Elite 3d installation"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Date: Mon, 11 Feb 2002 20:29:34 +0100
From: Till Jaeger <till.jaeger@epost.de>
Message-ID: <17739300711.20020211202934@epost.de>
Subject: Re[2]: [suse-sparc] Elite 3d installation

Hi Jerry,

> Do I have to remove the on-board controller from the pci probe list to
> disable it? My guess is not, since theoretically one should be able to
> use both for two monitors.

i've never tried to use both. But imho there is a way to give the primary
display as an OBP parameter?!
You should disconnect the old monitor at first. Are the afb drivers for solaris
installed? The afb config prog is "afbconfig".

-Till

-- 
To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com
For additional commands, e-mail: suse-sparc-help@suse.com

Next message: Till Jaeger: "Re: AW: [suse-sparc] Elite 3d installation"
Previous message: Kuhnkey, Mike E (N-Raytheon): "[suse-sparc] Installation: Sax2 and XFree86 for Sun Elite3D/Expert3D"
In reply to: Jerry Acord: "Re: [suse-sparc] Elite 3d installation"
Next in thread: Till Jaeger: "Re[2]: [suse-sparc] Elite 3d installation"
Reply: Kuhnkey, Mike E (N-Raytheon): "RE: Re[2]: [suse-sparc] Elite 3d installation"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.0 : Mon Feb 11 2002 - 11:35:16 PST