Message-ID: <3C6D0440.32F27B9F@amelektronikk.no> Date: Fri, 15 Feb 2002 13:51:12 +0100 From: Torbjørn Heltne <torbjorn.heltne@amelektronikk.no> Subject: Re: [suse-sparc] Lance Ethernet Adapter on SMP SS20
Thorsten Kukuk wrote:
>
> On Thu, Feb 14, Daniel Harris wrote:
>
> >
> > I have a SS20 SMP machine I have been running redhat 6.2 on for
> > what seems forever (well, atleast since release;)). I recently
> > wiped out the drives and installed Suse 7.3 on the system. The
> > install went fine except it does not seem to have a lance module
> > for my network card (which is built into the motherboard). I
> > know it used the Sun Lance drive in RH6.2, but now I am not sure
> > what to do with it. It is using the 2.2-smp kernel from a minimal
> > install. /lib/modules does not show the lance module which I
> > had used before. Any ideas?
>
> You cannot compile the lance driver as module, it is always compiled
> into the kernel. You only need to do a ifconfig eth0 up or use
> YaST2 to configure the network.
I have a SS20 SMP machine as well, and I configured eth0 during
installation. No problems.
Daniel: If you like, I am happy to send you various configuration files
for my system. Just tell me what you want, and I'll send it to you
directly.
-- Torbjørn Heltne AM Elektronikk AS-- To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com For additional commands, e-mail: suse-sparc-help@suse.com
This archive was generated by hypermail 2.1.0 : Fri Feb 15 2002 - 04:49:21 PST