[suse-sparc] Suse 7.3, sparcstation 20, QLogic scsi adapter

From: Christine Desmuke (CDesmuke_at_kshs.org)
Date: Fri Jul 05 2002 - 21:14:28 CEST

  • Next message: Scott A Micciche: "Re: [suse-sparc] Suse 7.3, sparcstation 20, QLogic scsi adapter" 

    Message-Id: <sd25a9e5.009@mothra.kshs.org>
Date: Fri, 05 Jul 2002 14:14:28 -0500
From: "Christine Desmuke" <CDesmuke@kshs.org>
Subject: [suse-sparc] Suse 7.3, sparcstation 20, QLogic scsi adapter

    I have recently inherited a SparcStation 20 with no internal hard drive, an external hard drive on a QLogic SBus card, and an internal CD-ROM. When I try to install Suse 7.3 from the cd-rom, it fails to see the hard drive.

    SunOS 5.6 is currently installed on the external drive and seems to run ok (at least, it boots without error). I want to replace it with Suse, but yast gets as far as probing hardware and reports "Error: no hard disks were found for the installation. Please check your hardware."

    probe-scsi-all returns:
    /iommu@f,e0000000/sbus@f,e0001000/QLGC,isp@0,10000
    Target 0
    Unit 0 Disk Seagate ST410800W ....

    How do I tell yast where to find the hard drive? Do I need to load a driver for the adapter, and if so, how?

    Thank you.

    Christine 

    -- 
To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com
For additional commands, e-mail: suse-sparc-help@suse.com

    This archive was generated by hypermail 2.1.0 : Fri Jul 05 2002 - 21:16:42 CEST