Message-ID: <001501c21397$0bb0f0d0$1400a8c0@nicksgp7> From: "Nick Thompson" <nthompso@cae.wisc.edu> Date: Fri, 14 Jun 2002 07:31:37 -0400 Subject: Re: [suse-sparc] Ultra 1 boot net/install: module inst_mode does not work
If all else fails, try redownloading the ISO file for first disk &
re-burning it. Or go buy the package with a pressed CD. This sounds too
much like an error in the ISO. You may have gotten lucky with your other
machines. Ultra 1 is 64 bit machine which will use 2.4 kernel, your other
machines were Sparc 32 bit machines which would've installed w/ 2.2 kernel.
Hence, the reason those installs went on without any problems.
my $0.02 (american)
----- Original Message -----
From: "Lou Picciano" <LouPicciano@comcast.net>
To: "SuSE SPARC LIST" <suse-sparc@suse.com>
Sent: Thursday, June 13, 2002 3:12 PM
Subject: [suse-sparc] Ultra 1 boot net/install: module inst_mode does not
work
> Dear List-ers:
>
> Am attempting an install of v7.3 onto an Ultra 1 (happen to be doing it,
> with Matthias' help, over bootp and tftp...)
>
> All is going OK with the kernel boot, and mount of the install CD.
>
> However, install stops after selecting the timezone with the error:
>
> The module inst_mode does not work
>
> I cannot Retry or Next from this dialog with success.
>
> Has anyone seen this before??
>
> Lou
>
>
> --
> To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com
> For additional commands, e-mail: suse-sparc-help@suse.com
>
>
>
-- To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com For additional commands, e-mail: suse-sparc-help@suse.com
This archive was generated by hypermail 2.1.0 : Fri Jun 14 2002 - 13:31:47 CEST