From: Andrew Hooper (andrew.hooper_at_dsl.pipex.com)
Date: Mon Jun 09 2003 - 11:08:58 CEST
From: "Andrew Hooper" <andrew.hooper@dsl.pipex.com> Date: Mon, 9 Jun 2003 10:08:58 +0100 Message-ID: <000001c32e66$c36342b0$0207a8c0@buffy> Subject: RE: [suse-sparc] Booting SParc 10
Hi
Just checking but have you checked that the SCSI bus is properly terminated
and that the device addresses are not overlapping. I would then try the
elimination system and take out all but the most needed disk(s)/devices and
add them in one by one once you get SuSE installed.
Good luck
Andrew Hooper
www.andrew.hooper.dsl.pipex.com
-----Original Message-----
From: sjardine@acm.org [mailto:sjardine@acm.org]
Sent: 09 June 2003 07:20
To: suse-sparc@suse.com
Subject: [suse-sparc] Booting SParc 10
Hello All,
New to list.
I am booting disk 1. I do a text or Yast2 install. I get into the
startup,
and after the scsi disks are recognized, I get a never ending list of SCSI
interrupt errors. Any ideas?
By the way - 2 Narrow SCSI disks, 2 Gb each and an external cartridge
type
cdrom. SMP system with 2 Ross 150 Mhz modules..
TIA.
Steve
-- To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com For additional commands, e-mail: suse-sparc-help@suse.com -- To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com For additional commands, e-mail: suse-sparc-help@suse.com
This archive was generated by hypermail 2.1.7 : Mon Jun 09 2003 - 11:09:00 CEST