sjardine_at_acm.org
Date: Tue Jun 10 2003 - 06:57:37 CEST
Date: Mon, 9 Jun 2003 21:57:37 -0700 Message-Id: <20030609215737.49bc2cc1.sjardine@acm.org> From: sjardine@acm.org Subject: Re: [suse-sparc] Booting SParc 10
Success..
Pulled out one hard drive and temporarily hung a cdrom over the first hard drive.
Connected cdrom drive to second hard drive cable. Boots, but now other media
issues occur during second session...
Until next time..
Steve
On Mon, 9 Jun 2003 10:08:58 +0100
"Andrew Hooper" <andrew.hooper@dsl.pipex.com> wrote:
> Hi
>
> Just checking but have you checked that the SCSI bus is properly terminated
> and that the device addresses are not overlapping. I would then try the
> elimination system and take out all but the most needed disk(s)/devices and
> add them in one by one once you get SuSE installed.
>
> Good luck
>
> Andrew Hooper
> www.andrew.hooper.dsl.pipex.com
>
> -----Original Message-----
> From: sjardine@acm.org [mailto:sjardine@acm.org]
> Sent: 09 June 2003 07:20
> To: suse-sparc@suse.com
> Subject: [suse-sparc] Booting SParc 10
>
>
> Hello All,
>
> New to list.
>
> I am booting disk 1. I do a text or Yast2 install. I get into the
> startup,
> and after the scsi disks are recognized, I get a never ending list of SCSI
> interrupt errors. Any ideas?
>
> By the way - 2 Narrow SCSI disks, 2 Gb each and an external cartridge
> type
> cdrom. SMP system with 2 Ross 150 Mhz modules..
>
>
> TIA.
>
>
> Steve
>
> --
> To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com
> For additional commands, e-mail: suse-sparc-help@suse.com
>
>
-- To unsubscribe, e-mail: suse-sparc-unsubscribe@suse.com For additional commands, e-mail: suse-sparc-help@suse.com
This archive was generated by hypermail 2.1.7 : Tue Jun 10 2003 - 06:57:29 CEST