<div dir="ltr"><div><div><div>Hello,<br><br>If I install beta5 with no registration/packages and select under settings to get the time from the NTP pool the screen with the timezone map shows me the right (updated) time.<br><br>But if I proceed with the installation the "Performing Installation" screen (Step: "Save Installation Settings" -> "Writing NTP Configuration...") shows a popup "Cannot adjust 'NTP' service.". This popup does not happen when I do not enable NTP. When clicking OK the installation proceeds.<br><br></div>Gruss<br></div>Bernd<br><br></div>PS: in the timezone selection the "hardware clock in UTC" does not adjust the currently displayed time. It is a bit frustrating when you select a timezone and the displayed current time is off by an hour. Because you have to switch on the UTC mode and then go to manual settings and correct the time (or turn on NTP as I did). I think former versions of SLES has that "feature" as well.<br></div>